Continuous stock runs versus permitted joined runs.

Continuous pieces must fit individual stock lengths; unrestricted joining permits arithmetic pooling but changes the assumed cut plan.

Calculate two independent purchase scenarios

Prefilled values are illustrative. Replace measurements and product data on both sides. Quantities with different units or different products cannot be combined. Open a result in its calculator to save it to your material project.

A worked purchase comparison

Three 3 m continuous courses need three 5 m boards. Unrestricted joining and reuse would pool 9 m into two 5 m boards. The one-board difference depends entirely on an explicitly permitted joint plan; the calculator does not authorize that change.

Use your measurements and selected products

Use selected board lengths, flat-slip packs and corner-unit packs. Enter the joint plan supplied for the job.

Measured Cladding Course Stock Calculator

Count cladding stock from individually measured course runs and exclusions, with explicit end-joint and reuse assumptions.

Brick Slip Flat and Corner Pack Calculator

Remove corner leg coverage from flat-slip demand and order corner units separately using each product pack.

Cladding Panel End Trim and Joint Order Calculator

Count separate panel courses after user-specified end trimming, with joint gaps only between neighbouring panels.

Render Bead Continuous Cut Order Calculator

Fit complete measured bead runs into selected stock lengths, keeping each continuous run unspliced.

What makes the comparison valid?

First-fit cutting produces a feasible stock count, not a guarantee of the smallest possible order. Corner units remain a separate product.

Illustrative quantities above are not market prices or construction recommendations. Compare actual permitted scenarios independently and keep alternative orders separate.

Next steps

Reviewed 5 October 2026. Search demand has not been measured.