Fascia board stock.
Measure separate board runs, including already specified end shapes.
Read the right quantitative data
Actual section, stock length and supplied cutting allowances.
Check this ordering assumption
One total perimeter hides run-by-run stock fit and any narrow exposed finish faces.
Use the existing detail; board selection and attachment remain separate.
A worked quantity method
This illustrative set of supplied inputs demonstrates Stock Cut List Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Usable stock length | 6 m | 19.69 ft |
| Kerf per cut | 0 mm | 0 in |
| Total end trimming per stock | 0 mm | 0 in |
| Cut item 1: Required cut length | 4 m | 13.12 ft |
| Cut item 1: Pieces | 2 | 2 |
| Cut item 2: Required cut length | 2 m | 6.56 ft |
| Cut item 2: Pieces | 2 | 2 |
Stock lengths for this allocation: 2 stock lengths
- Cut pieces
- 4
- Unallocated offcut after kerf
- 0 m
First-fit decreasing; the allocation is feasible but may not be optimal.
Open this example in the full calculatorYour measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
Measure separate board runs, including already specified end shapes.
Actual section, stock length and supplied cutting allowances.
One total perimeter hides run-by-run stock fit and any narrow exposed finish faces.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Paintable Trim Profile Surface Calculator
Estimate finish area from the developed exposed profile width, run lengths and separately measured end faces.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Apply banding cut allowance to every selected edge
- A reproducible two-stock cut plan can still cost more than another plan
- Keep first-emitter offset in a specified dripline takeoff
- Purchased stock length is not installed finished length
- Do not pool ridge lengths without checking cap cuts and overlaps
- Use the exposed contour width for painted trim
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.