Wall batten stock.
Read the supplied spacing pattern and count full run lengths along its chosen direction.
Read the right quantitative data
Actual stock lengths and explicitly specified boundary members.
Check this ordering assumption
A calculated count from chosen spacing is not a safe spacing recommendation.
Structural support, attachment and spacing requirements come from the existing plan.
A worked quantity method
This illustrative set of supplied inputs demonstrates Supplied Batten Grid Quantity Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Grid length | 4 m | 13.12 ft |
| Grid height | 3 m | 9.84 ft |
| Specified horizontal spacing | 1 m | 3.28 ft |
| Specified vertical spacing | 1 m | 3.28 ft |
Combined batten length: 31 m
- Vertical members
- 5
- Horizontal members
- 4
- Grid intersections
- 20
Your measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
Read the supplied spacing pattern and count full run lengths along its chosen direction.
Actual stock lengths and explicitly specified boundary members.
A calculated count from chosen spacing is not a safe spacing recommendation.
Input for Supplied Batten Grid Quantity Calculator. Record the value with its unit and quantity basis.
Input for Supplied Batten Grid Quantity Calculator. Record the value with its unit and quantity basis.
Input for Supplied Batten Grid Quantity Calculator. Record the value with its unit and quantity basis.
Input for Supplied Batten Grid Quantity Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Supplied Batten Grid Quantity Calculator
Count both directions of a specified rectangular batten grid, with separate edge inclusion and intersections.
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Apply banding cut allowance to every selected edge
- A reproducible two-stock cut plan can still cost more than another plan
- Keep first-emitter offset in a specified dripline takeoff
- Purchased stock length is not installed finished length
- Do not pool ridge lengths without checking cap cuts and overlaps
- Keep vertical route sections in a length takeoff
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.