Landscape edging pieces.
Measure each continuous run, with supplied corner and connector details listed separately.
Read the right quantitative data
Useful length per piece, connector allowance and usable stock length.
Check this ordering assumption
Nominal piece length can overstate installed coverage where pieces overlap or join.
Keep curved layout requirements and fixing details as supplied inputs.
A worked quantity method
This illustrative set of supplied inputs demonstrates Landscape Edging Piece Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Usable straight piece length | 2 m | 6.56 ft |
| Separate corner units | 4 | 4 |
| Separate end caps | 0 | 0 |
| Run 1: Straight run length | 5 m | 16.4 ft |
| Run 2: Straight run length | 3 m | 9.84 ft |
Straight edging pieces: 5 pieces
- Straight-to-straight joiners
- 3
- Corner units
- 4
- End caps
- 0
Your measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
Measure each continuous run, with supplied corner and connector details listed separately.
Useful length per piece, connector allowance and usable stock length.
Nominal piece length can overstate installed coverage where pieces overlap or join.
Input for Landscape Edging Piece Calculator. Record the value with its unit and quantity basis.
Input for Landscape Edging Piece Calculator. Record the value with its unit and quantity basis.
Input for Landscape Edging Piece Calculator. Record the value with its unit and quantity basis.
Input for Landscape Edging Piece Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Landscape Edging Piece Calculator
Count straight edging pieces, supplied corner units and joiners around measured runs.
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Apply banding cut allowance to every selected edge
- A reproducible two-stock cut plan can still cost more than another plan
- Keep first-emitter offset in a specified dripline takeoff
- Purchased stock length is not installed finished length
- Do not pool ridge lengths without checking cap cuts and overlaps
- Keep vertical route sections in a length takeoff
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.