Opening trim stock.
List head and side trim members on the specified inside or outside cut basis.
Read the right quantitative data
Actual profile width, stock length and prescribed end allowances.
Check this ordering assumption
A simple opening perimeter can be shorter than mitred outside-length trim blanks.
Use the selected corner geometry and joint arrangement.
A worked quantity method
This illustrative set of supplied inputs demonstrates Stock Cut List Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Usable stock length | 6 m | 19.69 ft |
| Kerf per cut | 0 mm | 0 in |
| Total end trimming per stock | 0 mm | 0 in |
| Cut item 1: Required cut length | 4 m | 13.12 ft |
| Cut item 1: Pieces | 2 | 2 |
| Cut item 2: Required cut length | 2 m | 6.56 ft |
| Cut item 2: Pieces | 2 | 2 |
Stock lengths for this allocation: 2 stock lengths
- Cut pieces
- 4
- Unallocated offcut after kerf
- 0 m
First-fit decreasing; the allocation is feasible but may not be optimal.
Open this example in the full calculatorYour measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
List head and side trim members on the specified inside or outside cut basis.
Actual profile width, stock length and prescribed end allowances.
A simple opening perimeter can be shorter than mitred outside-length trim blanks.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Input for Stock Cut List Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Mitered Frame Cut List Calculator
Measure the long-point cut lengths for a rectangular surround with supplied visible face width.
Trim Calculator
Estimate skirting or baseboard lengths after subtracting doorway gaps.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Keep butt-joint face-frame cuts separate from miter long points
- Apply banding cut allowance to every selected edge
- A reproducible two-stock cut plan can still cost more than another plan
- State end-cut angles relative to square before calculating blanks
- Keep first-emitter offset in a specified dripline takeoff
- Purchased stock length is not installed finished length
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.