MEASURE ONCE. PLAN YOUR PURCHASE.

Decorative Full Slat Face Stock calculator.

Count whole-width supplied decorative face strips that fit across measured rectangles and preserve complete vertical cut fit.

ACOUSTICS

Your inputs

Use measurements from your plan and properties from your chosen product. Any prefilled values are illustrative.

Selected stock length

Where to get this value

Use the actual usable quantity or dimensions of the product you intend to buy. Check the label and the unit shown here.

Your extra length reserved per cut

Selected slat face width

Where to get this value

Measure this dimension in your plan or on site and use the displayed unit. For irregular shapes, divide the geometry into the supported sections.

Gap already supplied for the face

Measured decorative face 1

Measured face width

Where to get this value

Measure this dimension in your plan or on site and use the displayed unit. For irregular shapes, divide the geometry into the supported sections.

Measured strip height

Where to get this value

Measure this dimension in your plan or on site and use the displayed unit. For irregular shapes, divide the geometry into the supported sections.

Identical faces

YOUR ESTIMATE

∑

A clear estimate starts here.

Enter your dimensions and product details to see the quantity and purchase breakdown.

CONTINUE YOUR PLAN

Find the next material.

Keep the quantity, then use another tool for the remaining parts of your purchase.

Explore all calculators

Formula and assumptions

BEHIND THE NUMBERS

How this calculation works.

Full-width strips across each face = floor((width + supplied gap)/(slat face width + supplied gap)); continuous cuts retain measured height and cut extra. Does not predict sound absorption, choose gap, fire performance or supporting design.

Full-width strips across each face = floor((width + supplied gap)/(slat face width + supplied gap)); continuous cuts retain measured height and cut extra.Calculated with normalised units

A worked example

Illustrative inputs only. Product properties and design dimensions are not recommendations for your project.

Selected stock length: 3 m
Your extra length reserved per cut: 0 m
Selected slat face width: 100 mm
Gap already supplied for the face: 100 mm
Measured face width: 1 m
Measured strip height: 2 m
Identical faces: 1

Slat stock lengths: 5 lengths

Continuous cuts use decreasing-length first-fit packing. This is a feasible count, not a guarantee of the minimum. Any per-cut extra is explicitly reserved by you. Only whole-width slats that fit are counted. Unfilled edge space is not assigned another trimmed slat. This is decorative quantity arithmetic, not acoustic performance.