Face frame stock.
Read the supplied rail and stile arrangement and record each complete member.
Read the right quantitative data
Actual member width, usable stock length and the chosen allowance.
Check this ordering assumption
Subtracting both stile widths is correct only for the supplied between-stile rail arrangement.
The page transcribes the chosen construction geometry.
A worked quantity method
This illustrative set of supplied inputs demonstrates Face Frame Cut List Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Outside frame width | 1 m | 3.28 ft |
| Outside frame height | 2 m | 6.56 ft |
| Specified stile face width | 0.1 m | 0.33 ft |
| Specified rail face width | 0.1 m | 0.33 ft |
| Specified frame thickness | 20 mm | 0.79 in |
| Horizontal rails per frame | 2 | 2 |
| Frames | 1 | 1 |
Total member cut length: 5.6 m
- Each between-stiles rail
- 0.8 m
- Remaining combined opening height
- 1.8 m
- Net frame material volume
- 0.01 m³
Your measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
Read the supplied rail and stile arrangement and record each complete member.
Actual member width, usable stock length and the chosen allowance.
Subtracting both stile widths is correct only for the supplied between-stile rail arrangement.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Face Frame Cut List Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Face Frame Cut List Calculator
Deduct continuous stile widths from the horizontal rail cut list.
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Keep butt-joint face-frame cuts separate from miter long points
- Apply banding cut allowance to every selected edge
- A reproducible two-stock cut plan can still cost more than another plan
- Include both end stiles in a decorative wall layout
- Keep first-emitter offset in a specified dripline takeoff
- Purchased stock length is not installed finished length
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.