Frame moulding stock.
Measure the intended opening, moulding face width and each supplied mitred member.
Read the right quantitative data
Usable stock lengths and cut allowances on the stated inside or outside dimension basis.
Check this ordering assumption
Inside opening lengths are shorter than the corresponding outside purchase blanks.
Mitre angles and finished frame geometry are supplied.
A worked quantity method
This illustrative set of supplied inputs demonstrates Mitered Frame Cut List Calculator. Replace the example measurements and product figures with your own before ordering.
| Supplied input | Metric display | US display |
|---|---|---|
| Inside opening width | 1 m | 3.28 ft |
| Inside opening height | 2 m | 6.56 ft |
| Frame face width | 0.1 m | 0.33 ft |
| Identical frames | 1 | 1 |
Combined long-point cut length: 6.8 m
- Horizontal piece long point
- 1.2 m
- Horizontal pieces
- 2
- Vertical piece long point
- 2.2 m
- Vertical pieces
- 2
Your measurement and product-data sheet
Record what you know and mark verified items ready. Notes save on this browser after you edit them. Download a copy before clearing browser data.
Measure the intended opening, moulding face width and each supplied mitred member.
Usable stock lengths and cut allowances on the stated inside or outside dimension basis.
Inside opening lengths are shorter than the corresponding outside purchase blanks.
Input for Mitered Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Mitered Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Mitered Frame Cut List Calculator. Record the value with its unit and quantity basis.
Input for Mitered Frame Cut List Calculator. Record the value with its unit and quantity basis.
Choose your next calculation
Mitered Frame Cut List Calculator
Measure the long-point cut lengths for a rectangular surround with supplied visible face width.
Angled End Cut Blank Calculator
Translate a supplied short edge and two end angles into long-edge cut blanks.
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Turn the estimate into an order
- Confirm that all quantities use the same measured basis and the selected product's current data.
- Keep different products, finishes and handed variants in separate purchase lines.
- Review exact demand and whole-pack purchase quantities before entering your quoted prices.
- Record compatible stock already on hand, then save the remaining order in your browser project.
Measurement and purchase guides
- Short versus long film rolls for continuous load wraps: quantity checks
- Keep butt-joint face-frame cuts separate from miter long points
- Apply banding cut allowance to every selected edge
- State end-cut angles relative to square before calculating blanks
- Keep first-emitter offset in a specified dripline takeoff
- Separate plank starter cuts from end offcuts
Other materials in this family
Reviewed 6 October 2026. Geometry and purchase arithmetic use your measurements and selected specifications. Calculation scope.