Stock lengths, sheets and usable offcuts.
Keep whole piece fit, cutting losses and algorithm limits visible before rounding stock.
Choose the matching calculation
Stock Cut List Calculator
Group required straight cuts into available equal-length stock, allowing for kerf and end trimming.
Sheet Cut Yield Calculator
Find a grid cutting yield for equal rectangular pieces, including saw kerf.
Board Resaw Yield Calculator
Count finished equal-thickness boards from a supplied blank, saw kerf and surfacing allowance.
Sheet Strip Rip Calculator
Calculate long strips ripped from sheet width after total edge trim and saw kerf.
Offcut Reuse Value Calculator
Compare the cost of new stock with the quoted processing cost for usable offcuts.
Mixed Rectangle Sheet Layout Calculator
Build a feasible rectangular cut allocation for different rectangular panels, respecting your rotation choice and cutting gap.
Measured Exclusion Board Piece Yield Calculator
Count equal pieces that fit the usable intervals of one board after measured excluded zones and per-piece cut loss.
Two Stock Length Cut Plan Calculator
Construct a cut allocation when two purchasable lengths have different prices.
Angled End Cut Blank Calculator
Translate a supplied short edge and two end angles into long-edge cut blanks.
Measure and check your assumptions
A reproducible two-stock cut plan can still cost more than another plan
Does choosing the cheapest feasible new stock prove the cheapest full order?
Purchased stock length is not installed finished length
Which losses have already been included in the installed cut list?
Treat net panel area as a lower bound, not a sheet layout
Why can a feasible mixed-panel allocation use more sheets than total area suggests?
Account for resaw kerf and surfacing allowances
Why is blank thickness divided by finished thickness an optimistic resaw yield?
Distinguish sheet ripping from rectangle nesting
Which cutting model should be used for long strips?
Value offcuts after preparation cost
When does using compatible offcut stock actually save purchase money?
Compare a curved sleeve’s developed area with its rectangular bounding sheet
Why is circumference times height not a cone’s developed sheet shape?
Read between-sides dimensions in a drawer panel list
Does an outside width belong on a front cut that fits between side panels?
Apply banding cut allowance to every selected edge
Is end trim counted per panel or per banding cut?
State end-cut angles relative to square before calculating blanks
Is a supplied angle measured from a square end or from the board edge?
Keep first-emitter offset in a specified dripline takeoff
Does a run’s start coincide with an emitter position?
Check offcut width and direction before counting sod reuse
Is an equal offcut area enough to replace a required full strip?
Keep the estimate within scope
Use your measured geometry and already supplied product specifications. Counts and quantities do not select a construction system or establish code compliance.
Collect chosen results in a free browser material project. Alternative scenarios remain separate orders.