Furniture panels and joinery cut quantities.
Use supplied panel dimensions, overlays, margins and joins to count furniture material.
Choose the matching calculation
Mitered Frame Cut List Calculator
Measure the long-point cut lengths for a rectangular surround with supplied visible face width.
Supplied Cabinet Door Overlay Calculator
Calculate equal door leaf dimensions from an opening and overlays or reveals already chosen in your plan.
Equal Drawer Front Grid Calculator
Divide a specified cabinet face into equal drawer fronts after outer reveals and gaps between fronts.
Furniture Panel Finish Surface Calculator
Total selected panel faces and edges for finishing furniture from actual dimensions and exposed-side counts.
Drawer Box Panel Cut List Calculator
Generate five panel blanks for an explicitly supplied drawer-box arrangement.
Face Frame Cut List Calculator
Deduct continuous stile widths from the horizontal rail cut list.
Equal Compartment Divider Layout Calculator
Distribute an existing shelf opening into equal compartments after divider deductions.
Panel Edge Banding Cut Order Calculator
Count selected panel edges and apply trim allowance to each cut, not each panel.
Timber Glue-Up Width Calculator
Account for preparation on every board before trimming a specified assembled panel.
Polygonal Stave Ring Geometry Calculator
Measure the inside and outside widths of an already specified polygonal stave ring.
Specified Planter Board Cut List Calculator
Coordinate supplied wall board cuts with the inside dimensions used for fill.
Measure and check your assumptions
Keep butt-joint face-frame cuts separate from miter long points
Do rails fit between continuous stiles or meet at mitered corners?
Translate a supplied opening into overlay or inset leaf dimensions
Where does the centre gap belong when two equal doors share one opening?
Subtract shared face reveals before dividing drawer fronts
Why can dividing cabinet height by drawer count make the fronts too tall?
Read between-sides dimensions in a drawer panel list
Does an outside width belong on a front cut that fits between side panels?
Deduct divider thickness before dividing equal clear openings
Why are completed compartments narrower than width divided by count?
Apply banding cut allowance to every selected edge
Is end trim counted per panel or per banding cut?
Separate per-board preparation from final panel trim
Does a repeated edge loss need to be applied before assembling panel width?
Read inside face distance rather than inside corner radius for staves
Does the inside ring dimension end at a flat face or a vertex?
State end-cut angles relative to square before calculating blanks
Is a supplied angle measured from a square end or from the board edge?
Include both end stiles in a decorative wall layout
Why does a row of three panel openings need four vertical strips?
Use inside planter dimensions for fill and outside dimensions for board cuts
Can the same outside dimensions be used unchanged for both material quantities?
Include exposed panel edges in a furniture finish estimate
When does two-face panel area still omit a paintable surface?
Keep the estimate within scope
Use your measured geometry and already supplied product specifications. Counts and quantities do not select a construction system or establish code compliance.
Collect chosen results in a free browser material project. Alternative scenarios remain separate orders.